Welcome to British Parts Northwest!

Order by Phone 503-864-2001
‹ Back

Clutch Slave Cylinder OE TR250 TR6

Part number: PJL705

Availability: In stock



  • Sunbeam Alpine 1963 to 1967 (from ch.# B94102369 on) 

  • Triumph TR250, Triumph TR6

Clutch Slave Cylinder OE TR250 TR6

Double click on above image to view full picture

Zoom Out
Zoom In

More Views

This is an OE Clutch Slave Cylinder For Triumph TR250, Triumph TR6 and Triumph STAG. Being and original slave cylinder it is a one inch bore and has the correct casting like original. Put a quality slave cylinder on your Triumph TR250 and Triumph TR6. Cross Ref.# 4253-284, L4253-284, UKC8677.

What are the symptoms of a bad clutch slave cylinder?

Usually when you have a bad clutch slave cylinder you know it right away, because since it is a hydraulic part, once a seal inside the slave cylinder gets bad, it will start leaking fluid, at the same time, because the seal is not sealing properly, it will allow air inside the system, causing your clutch pedal to feel soft and spongy. When a clutch pedal feels that way, it is an indication of air in the system, and when this happens, it makes it hard to operate the clutch properly because it engages even with your foot almost all the way to the floor, at times you may not even be able to place your car in gear due to this problem. NOTE: A bad clutch master cylinder will have similar symptoms, make sure that you look closely at each one of these items to determine which one is the problem ( the one malfunctioning is the one leaking fluid ).

click here